Published October 2026. Updated October 2026.
Quick answer
A session log is a table you fill in after each session with the facts of the setup: date, device, distance, stated irradiance, minutes and the calculated J/cm² = mW/cm² x minutes x 60 / 1000. Its job is consistency and honest arithmetic. It is not a place to score how you feel or to record claims. Nine columns are enough, and a spreadsheet can do the sums for you.
Why keep a log at all
Most people who use a light device for a few weeks cannot say exactly what they did. Was it 10 minutes or 15? Six inches or a foot? Without a record, any later comparison is guesswork. A log fixes the boring part. It tells you what the setup was, so the numbers on the page are the numbers you actually used.
It also protects you from arithmetic slips. If you copy the stated irradiance for each distance into the log once, you will not be recalculating from memory. The dose guide explains the formula, and the dose calculator will check any line.
The nine fields worth recording
| Field | Example entry | Why it is there |
|---|---|---|
| Date and start time | Oct 6, 7:30 | Lets you count sessions per week and spot gaps. |
| Device and model | FX300 | Different devices have different stated irradiance. |
| Mode or setting | Default | Some devices have modes or intensity levels. Write down which one you used. |
| Distance | 6 in | Irradiance is only meaningful with its distance attached. |
| Stated irradiance | 83.5 mW/cm² | Copy it from the spec sheet for that distance, with the source. |
| Minutes run | 10 | The timer setting or your own clock, whichever you trust. |
| Calculated J/cm² | 50.1 | Irradiance x minutes x 0.06. A formula answer, not a measurement. |
| Position or zone | Front torso | Helps you repeat the same setup and add up zones separately. |
| Notes on setup | Goggles on, door hook | Facts about the setup only. |
Keep each entry short. If a field takes more than a few seconds to fill in, you will stop filling it in.
A sample week, with example numbers
The rows below show what a filled in log looks like for one week. The irradiance figures are the published FX300 values at 6 and 12 inches. The minutes and zones are example numbers for arithmetic only and are not a plan.
| Day | Device | Distance | Irradiance (mW/cm²) | Minutes | J/cm² (calc) | Zone |
|---|---|---|---|---|---|---|
| Mon | FX300 | 6 in | 83.5 | 10 | 50.1 | Front torso |
| Wed | FX300 | 6 in | 83.5 | 10 | 50.1 | Back |
| Fri | FX300 | 12 in | 43.3 | 15 | 38.97 | Front torso |
| Sat | FX300 | 6 in | 83.5 | 5 | 25.05 | Shoulders |
Adding the four lines gives 164.22 J/cm² for the week. That total has a catch: the lines are for different distances and zones, so adding them mixes things. A weekly planning guide in this series covers how to add up carefully. For now, the point is that the log makes the mixing visible.
Setting it up in a spreadsheet
Put the nine fields in columns A to I. Then make the calculated column do the work.
- Calculated J/cm²: if irradiance is in column E and minutes in column F, type =E2*F2*60/1000 and fill down.
- Weekly sessions: a COUNTIFS on a week number column gives sessions per week.
- Totals by zone: a SUMIFS on the zone column keeps different areas apart.
- Data validation: a drop down for device and distance stops typos like "6 inches" versus "6 in".
On paper, the same nine columns on a printed grid work fine. Use pencil and write minutes as numbers, not as "about ten".
What to leave out
- Claims about what the light did. A log with claims in it is no longer a neutral record.
- Medical details. If you keep personal notes, keep them somewhere separate and share them only with a qualified professional.
- Estimates dressed up as facts. If you did not measure a distance, write "approx" next to it.
- Anything you will not realistically record every time.
A monthly review that takes five minutes
- Count the sessions. Did the log match what you intended?
- Scan the distance column. Did it drift?
- Scan the minutes column against your manual. Did any line stray from the device guidance?
- Check three lines of arithmetic with the calculator.
- Write one sentence about what you will change next month, or nothing.
If anything in the log raises a medical question, that is a question for a qualified professional, not for a spreadsheet.
Related tracking ideas, such as what to write after each session and how to plan a weekly total, are covered in separate guides in this series.
Common mistakes
- Logging only the date and not the distance or minutes.
- Writing irradiance from memory instead of copying it from the spec sheet.
- Mixing minutes and seconds in the same column.
- Adding J/cm² from different distances or zones as if they were one patch of surface.
- Using the log to record claims instead of setup facts.
- Changing the column layout every week so the data cannot be compared.
Before you use any light device: read the label, follow the device manual, and use eye protection as directed. This guide is general information about arithmetic and planning, not medical advice. For medical questions, speak to a qualified professional.
Related guides and tools
- How to calculate your dose
- How long a session runs, by the manual
- AWA FX300 and FX500 irradiance specs
- Choosing a time of day
- Wavelengths, sessions and devices explained
- Red light dose calculator
- Session time table
Device pages
Read the full page and label for each device before you use it: AWA FX300 panel, AWA FX500 panel. You can also browse the AWA panels, or the Learning Center for more guides.
Frequently asked questions
What should a red light therapy session log include?
At least the date, device, distance, stated irradiance, minutes run and the calculated J/cm². A zone column and a setup note make the log easier to repeat.
Do I need an app?
No. A paper grid or a basic spreadsheet is enough. The value is in recording the same fields every time.
How do I calculate J/cm² in the log?
Multiply irradiance in mW/cm² by minutes and by 60, then divide by 1000. In a spreadsheet that is =E2*F2*60/1000 when irradiance is in E and minutes in F.
Should I record how I feel?
This guide keeps the log to setup facts. If you want personal notes, keep them separate, and ask a qualified professional about any medical question.
How long should I keep the log?
Keep it as long as it helps you repeat a consistent setup. There is no required period.
Sources
- FDA: General Wellness: Policy for Low Risk Devices. January 2026 guidance from the FDA Center for Devices and Radiological Health on its compliance policy for low risk general wellness products. It is a policy document, not a statement about any one device.
- FDA: Premarket Notification 510(k). Explains that companies generally must submit a 510(k) before marketing certain medical devices in the U.S., showing substantial equivalence to a legally marketed device.
Regulatory note: select devices carry FDA 510(k) clearance for specific, limited uses; most are sold as general wellness products. Read each product page and label.
How we create this guide
AWA sells red light therapy devices. We write these guides to explain how devices work and how to choose and use one. This is general information, not medical advice. Read each product page and label. See our editorial standards.



